# How many sets per muscle per week?

> Most lifters build muscle well on about 10 to 20 hard sets per muscle a week. More sets give more growth, but each extra set adds less. Count a set fully for the muscle it mainly trains and as half a set for the muscles that help, skip warm-ups, and end most sets within a few reps of failure.

Source: https://templatetrainer.com/guides/sets-per-muscle-per-week/ · By Jordan DuBois · Updated 2026-11-21 · Template Trainer

**Weekly sets per muscle** is the number of hard working sets a muscle gets across a whole week of training. It's the simplest useful way to measure training volume for muscle growth, and most programs built for size give each major muscle somewhere around **10 to 20 sets a week**.

That range is a starting point, not a law. Below it, many people grow more slowly than they could. Above it, growth usually keeps climbing, just more slowly, while recovery gets harder. This guide covers how to count your sets, what the research says about more and fewer, and how to check a program before you run it.

## What counts as a set?

Only **working sets** count. A set counts when it's hard enough to matter for growth:

- **Warm-ups don't count.** The empty bar and the ramp up to your first working weight are practice, not stimulus.
- **The rep count matters less than the effort.** A set of 8 and a set of 15 both count as one set, as long as each ends close to failure.
- **Effort is what makes a set count.** A set that stops with eight reps still in the tank does far less than one that stops with one or two left.

A 2024 series of meta-regressions by Robinson and colleagues found that muscle size gains went up as sets were taken closer to failure. Strength gains, on the other hand, had almost no relationship with how close to failure people trained. The authors called their analysis exploratory, but the practical point is clear: for muscle, the sets you count should be hard ones. If you rate your sets, most should land around [RPE 7 to 9](https://templatetrainer.com/guides/what-is-rpe/), or one to three reps short of failure.

## How do you count sets from compound lifts?

A bench press trains your chest, but it also trains your triceps and the front of your shoulders. So how many sets is it?

The most useful answer is the **fractional** count: **one set for the muscle the exercise mainly trains, and half a set for each muscle that helps.** A few lifts, like rows, train two muscles about equally, so both get the full set.

| Exercise, 3 working sets | Main muscle | Helping muscles |
| --- | --- | --- |
| Bench press | Chest: 3 | Triceps 1.5, front delts 1.5 |
| Barbell row | Upper back and lats: 3 each | Biceps 1.5, rear delts 1.5 |
| Romanian deadlift | Hamstrings: 3 | Glutes 1.5, lower back 1.5 |
| Lateral raise | Side delts: 3 | None |

Pelland and colleagues tested several ways of counting indirect work across the volume research, and the fractional count predicted muscle growth best. Counting every helper muscle as a full set overstates how much a program trains your arms and shoulders; ignoring them altogether understates it.

## How many sets per week do you need?

The short answer: **more sets give more growth, with diminishing returns.**

Pelland's meta-regressions found that muscle growth kept rising as weekly sets went up, with a smaller gain from each extra set. Strength followed a flatter curve, with the returns tailing off much sooner. In other words, a strength-focused lifter can get most of the benefit from fewer sets, while someone chasing size has more to gain from adding volume.

In practice:

- **Under 10 hard sets a week** still builds muscle, and it's a fine place to start if you're new or short on time. You'll likely grow more slowly than you could.
- **10 to 20 sets a week** is where most well-designed hypertrophy programs land for each major muscle.
- **Over 20 sets a week** isn't automatically too much. Growth tends to keep rising, but each set adds less and costs more recovery. Go there for a muscle you want to bring up, not for everything at once.

If you add sets, add them gradually, a few per muscle at a time, and watch whether your logged weights and reps keep climbing. Sets that make the rest of your week worse aren't helping.

## Does frequency matter?

Frequency is how many days a week you train a muscle. A 2016 meta-analysis by Schoenfeld, Ogborn and Krieger found that, with the same weekly volume, training a muscle at least twice a week built more muscle than training it once. Whether three times beats twice was still undetermined.

Pelland's later analysis, with more studies, found that once weekly volume is equal, frequency on its own made little difference to muscle growth. For strength, more frequent practice did help, with diminishing returns.

The useful takeaway is that frequency is mostly a way to **fit your sets in**. Twenty sets for your chest in one session is miserable, and the last ten will be junk. Split across two or three sessions, each set gets your full effort. That's why splits like [push pull legs](https://templatetrainer.com/guides/push-pull-legs-split/) and upper/lower hit each muscle twice a week.

## A worked example: the Reddit PPL

Here's how the Reddit push pull legs routine counts up as written, at six sessions a week, using the one-and-a-half rule above:

| Muscle | Sets per week |
| --- | --- |
| Chest | 12 |
| Quads | 13.5 |
| Hamstrings | 15 |
| Side delts | 15 |
| Lats | 18 |
| Biceps | 26.5 |

Most muscles sit inside the 10 to 20 range. Biceps run high, because they get four sets each of two curls on both pull days on top of half sets from every row and pulldown. That isn't a problem, but if your elbows complain, dropping one curl is an easy fix.

## How to check your own program

1. **List every working set for a week.** Leave out warm-ups.
2. **Give each set to its main muscle,** and half a set to each muscle that helps.
3. **Add them up per muscle** and compare with 10 to 20.
4. **Fix the gaps first.** A muscle with almost no sets is a bigger problem than one a few sets over the range.
5. **Keep the effort high** and add weight or reps over time with [progressive overload](https://templatetrainer.com/guides/progressive-overload/). The count only means something if the sets are hard.

## How Template Trainer counts sets per muscle

Template Trainer does this count for you. Open a program in the program editor and go to the **Details** tab: **Sets per muscle** shows each muscle's working sets per cycle or per week, worked out with the same rules as this guide. Warm-up sets aren't counted, a circuit counts one set per round, and each exercise's main muscle gets a full set while its other muscles get half. Muscles under 10 sets a week are marked **Low**, and muscles over 20 are marked **Above** the common range, not as too much. It also compares push against pull and quads against hamstrings, so a lopsided split stands out.

Two things it can't see: how hard your sets are, and logic rules that add or remove sets as the cycle goes. The numbers are the sets as written, so they match the research only when your working sets end close to failure.

## Frequently asked questions

### Is 10 sets per muscle per week enough?

For most people, yes, especially when the sets are hard. Ten is a common floor for muscle-building programs. If you're progressing well, there's no need to add more. If you stall on a muscle you care about, adding a few sets is one of the first things to try.

### Are 20 sets per muscle per week too much?

Not necessarily. Growth tends to keep rising past 20 sets, but each set adds less and recovery becomes the limit. If your weights and reps keep going up and you feel recovered, it's working. If performance drops week to week, cut back or take a [deload](https://templatetrainer.com/guides/what-is-a-deload/).

### Do warm-up sets count toward weekly volume?

No. Only working sets, taken within a few reps of failure, count. Warm-ups prepare you for those sets.

### Do compound lifts count for the smaller muscles?

Partly. Count a bench press as a full set for chest and half a set each for triceps and front delts. That fractional count matched muscle growth in the research better than counting helpers as full sets or not at all.

### Should beginners do 20 sets per muscle?

Usually not. When you're new, almost any hard training builds muscle, and the main job is learning the lifts. Start nearer 10 sets a muscle, or below if that's all you have time for, and add volume when your progress slows.

## Sources

- [Pelland et al. (preprint 2024, published 2025), The resistance training dose response: meta-regressions exploring the effects of weekly volume and frequency on muscle hypertrophy and strength gains, SportRxiv](https://sportrxiv.org/index.php/server/preprint/view/460)
- [Robinson et al. (2024), Exploring the dose-response relationship between estimated resistance training proximity to failure, strength gain, and muscle hypertrophy: a series of meta-regressions, Sports Medicine](https://rke.abertay.ac.uk/en/publications/exploring-the-dose-response-relationship-between-estimated-resist/)
- [Schoenfeld, Ogborn and Krieger (2016), Effects of resistance training frequency on measures of muscle hypertrophy: a systematic review and meta-analysis, Sports Medicine](https://pubmed.ncbi.nlm.nih.gov/27102172/)

## About the author

Jordan DuBois has been lifting for 20 years and won the men's open lightweight class at the 2013 NPC Natural Western in Arizona as a natural, after placing 2nd at the 2011 NPC Western Regional. Jordan holds summa cum laude degrees in applied mathematics and biology from Arizona State University, and founded Template Trainer to run proven programs the way their authors wrote them. [Bio](https://templatetrainer.com/authors/jordan-dubois/)
